VEN干燥剂
首页 / 资源中心 / 一个集装箱需要多少干燥剂包?20ft 与 40ft 用量指南

一个集装箱需要多少干燥剂包?20ft 与 40ft 用量指南

发往海湾运输的实用公式、参考用量和放置规则。



"How many desiccant bags do I need for a 20ft or 40ft container?" is the question we get more than any other from importers shipping to the Gulf. There is no fixed number 鈥?the right quantity depends on the cargo, the voyage, the season and the climate at the destination port. This guide gives you a dosage table you can work from directly, a method you can run yourself, and the specification points that decide whether the system actually holds.

为什么数量不是一个固定数字

Two things have to be true at once. The total capacity has to exceed every gram of water vapour that enters the container over the voyage, and the absorption rate has to keep pace with the rate at which that vapour appears. The first decides whether you have enough; the second decides whether it gets there in time. So the quantity is never a constant 鈥?three variables drive it:

One myth worth clearing up first: timber at 15% moisture content does not release 3,000 kg of water on a 20-tonne load. What actually migrates is the thin surface layer coming into equilibrium with the air in the box 鈥?typically under 0.1% of the cargo weight, around 20 kg on 20 tonnes. That is why dosage is sized from container volume and cargo type, not from moisture content.

For a well-specified calcium chloride container desiccant the industry rule of thumb is 1 kg per 2鈥? cubic metres of container air. The 4 m鲁 end covers general dry cargo; the 2 m鲁 end covers hygroscopic cargo or long voyages. On a 20ft box at roughly 33 m鲁 that works out at 8鈥?6 units of 1 kg (our strips run 1 kg each, five to a chain pack). It sits deliberately on the conservative side 鈥?treat it as a ceiling and take the working number from the table below.

One point usually left out of dosage guides: calcium chloride will take up twice its own weight in water under lab conditions, but a container is not a lab. Across space, airflow and temperature swings, our own measurements show the strips finishing a voyage somewhere between 140% and 180% of their dry weight. Every calculation on this page uses 140% 鈥?the cautious end.

20ft 与 40ft 集装箱参考用量

下表是氯化钙集装箱干燥剂(海运的标准选择)的实用起始用量。以此为基准,再按航程长短、货物类型以及箱内温湿度变化上下调整。

集装箱内部容积普通货物(参考)吸湿性货物(参考)
20ft(标准箱)~33 m鲁6鈥?0 units of 1 kg10鈥?6 units of 1 kg
40ft(大箱)~67 m鲁12鈥?0 units of 1 kg20鈥?2 units of 1 kg
40ft 高柜~76 m鲁14鈥?2 units of 1 kg22鈥?6 units of 1 kg

These figures assume a typical 20鈥?0 day voyage in temperate-to-tropical conditions. For peak-season Gulf arrivals (Jun鈥揝ep), or for very damp cargo such as green timber or leather, take the top of the range or one step above it. They also assume a full container you control; consolidated LCL cargo needs a different allowance.

如何更精确地估算

表格能覆盖大多数情况。如果货物特殊、航程很长,按下面四步修正:

  1. 取基准:从表格查出该箱型和货物类型对应的条数区间。
  2. Voyage adjustment: beyond 30 days, add 10鈥?5% for every extra 10 days.
  3. Safety margin: add 30鈥?0% for weather disruption and port delays 鈥?unless you already took the top of the table range, in which case that margin is priced in and must not be added twice.
  4. Ceiling check: run the rule of thumb (1 kg per 2鈥? m鲁) backwards. Whatever it returns is the ceiling; do not go far past it.

An example. A 40ft high cube carrying 25 tonnes of green timber to Dubai in August, 25 days at sea. First, the table gives 22鈥?6 units for hygroscopic cargo; the load is damp, so take the top 鈥?36. Second, 25 days stays inside the 30-day baseline, so no voyage adjustment. Third, the top of the range already carries the safety margin, so nothing is added. Fourth, the ceiling check: 76 m鲁 梅 2 = 38 kg, and 36 sits under it with a little room. The shipment goes out with 36 units.

If the check ever lands below the table figure, something in the inputs is wrong 鈥?the cargo is drier than assumed, or the pack format should be a larger unit. Running two methods against each other is how you arrive at a number that is neither reckless nor wasteful.

放置位置与数量同样重要

把所有干燥剂堆在一个角落,保护不了整个集装箱。要起作用,干燥剂必须分散布置,作用于真正发生凝结的那部分空气:

氯化钙还是硅胶?

For ocean freight the default is calcium chloride: high capacity, and it keeps absorbing at high relative humidity. Silica gel suits sealed packaging 鈥?electronics, pharma, food 鈥?where the pack is airtight and humidity stays moderate; it is cleaner and will not leak. Plenty of exporters use both, sachets inside cartons and strips on the walls, as two layers of protection.

导致索赔的常见错误

常见问题

一个 40ft 集装箱要放多少干燥剂?

12鈥?0 units of 1 kg for general dry cargo, 20鈥?2 for hygroscopic cargo. A 40ft high cube takes 14鈥?2 and 22鈥?6 respectively.

一条 1 kg 氯化钙能吸多少水?

Twice its own weight in theory. Under real ocean conditions our measurements come out at 140鈥?80%, and we size at 140%.

硅胶可以替代氯化钙吗?

Inside sealed packaging, yes. For a full container, no 鈥?silica gel loses capacity sharply above 80% relative humidity and holds far less water per unit of volume.

干燥剂应该挂多高?

与货物齐平或略高即可。沿箱体长度均匀分布,比挂得多高更重要。

获取你货物的用量建议

告诉我们集装箱尺寸、货物类型、重量和目的港,我们会算出确切条数。

相关产品与指南

💬 WhatsApp